Attic Spray Foam Insulation Spring, TX 77373 | Houston Spray Foam Insulation

Spray Foam Insulation in Spring, TX (77373) · Local Professionals

Houston Spray Foam Insulation · Fast response in Spring and the Houston area · Free estimate 24h

✅ Written Estimates with R-Value & Thickness Specs 🛡️ Fully Insured 💸 Free Quote 24h 🕐 Mon-Sat 7am-6pm

+29Verified Reviews

14Years in Business

4.9 ★Google Rating

24/7Available

Spring's 1980s and 1990s subdivisions between I-45 and the Grand Parkway are built on slab-on-grade foundations with vented attics that route all the ductwork overhead, where summer temperatures climb to 130 to 150 degrees Fahrenheit from May through October. That hot attic is the single biggest driver of your cooling bill, and the aging batts and leaky can-light ceilings in most homes here have stopped doing their job.

Homeowners in Spring call Houston Spray Foam Insulation when their energy bills become unaffordable, when a bedroom or bonus room never reaches temperature, or when they spot moisture and damp insulation in the attic. We have been serving Spring and the surrounding Houston area since 2012, and we know exactly what these homes need.

Spray Foam Insulation in Spring (77373)

Spring's housing stock is built for a climate that punishes poor insulation. Your attic sits directly under a roof that bakes in the Texas sun, and the ductwork running through that attic loses conditioned air before it ever reaches your rooms. The original fiberglass batts have compressed and settled over twenty to thirty years, leaving gaps and thin spots. Moisture from the Gulf Coast humidity condenses on cold ductwork in summer and wicks into the insulation, turning it into a soggy, ineffective blanket. Closed-cell spray foam stops that moisture at the surface, seals every gap and penetration, and holds its R-value for decades.

We also handle wall and injection foam for homes where the cavities were never filled, crawl spaces under older raised sections, rim and band joists where the rim board meets the foundation, and complete insulation removal when old material is too wet or contaminated to work around. Our team is fully insured with general liability and workers' compensation coverage.

Our services in Spring

Attic Spray Foam Insulation in Spring · Open-cell foam on the roof deck turns a 140°F Houston attic into conditioned…
Closed Cell Spray Foam Insulation in Spring · Two-pound closed-cell foam delivers R-6.5 per inch…
Open Cell Spray Foam Insulation in Spring · Half-pound open-cell foam air-seals attics and walls at a friendlier price per…
Wall & Injection Foam Insulation in Spring · Injection foam fills closed walls through small drilled ports, no demolition.
Crawl Space Spray Foam Insulation in Spring · Closed-cell foam on pier-and-beam subfloors and crawl space walls holds back…
Rim Joist & Band Joist Spray Foam in Spring · Band joists, cantilevers and bonus-room floors leak conditioned air at every…
Garage Spray Foam Insulation in Spring · Garage ceilings under bonus rooms and walls shared with the house…
Metal Building & Barndominium Spray Foam in Spring · Closed-cell foam is the only insulation that stops a Texas metal building from…
Commercial & New Construction Spray Foam in Spring · Warehouses, offices, churches and production builders served on schedule.
Insulation Removal in Spring · Old blown-in and batts vacuumed out before any new foam goes in, never buried.
Insulation Replacement & Re-Insulation in Spring · The full reset: old material removed, gaps air-sealed…
Air Sealing in Spring · Top plates, can lights, chases and hatches leak more cooled air than most walls.

How a Job Works in Spring

We start with a free on-site assessment. We walk your attic, crawl space or wall cavities, measure the area, check the existing insulation, look for moisture and air leaks, and listen to what your comfort and energy bill look like right now. We leave you with a written estimate that specifies the R-value we are targeting, the thickness of foam we will apply, whether we are using open or closed cell, and what has to happen before we spray (removal of wet insulation, air sealing of gaps, or mechanical ventilation during cure).

On the job day, we bring our spray rig and crew, set up mechanical ventilation to manage odor and off-gassing during application, and spray the foam in controlled passes to hit the thickness and coverage in your estimate. If insulation has to come out first, we remove it, haul it away, and clean the space before we spray. We work around your occupied home with a stated re-entry window of twenty-four to forty-eight hours. When we are done, we clean up, walk the space with you, and answer any questions about the work and the cure period.

Attic spray foam in Spring typically runs from $1.50 per square foot for open-cell to $1.20 per board foot for closed-cell, depending on the thickness and R-value your home needs. A typical 1,500 square foot attic with six inches of closed-cell foam runs between $9,000 and $12,000. Wall and injection foam for a room or a section of closed cavities runs from $2 per square foot. Crawl spaces start at $2,500. Insulation removal (a necessary first step if your existing material is wet or contaminated) starts at $950. The final price depends on how much area we are covering, how thick the foam needs to be to hit your R-value target, what has to be removed first, and how easy the access is. Call us at (346) 322-2588 for a free estimate, and we will walk you through the numbers for your specific home.

✅ Written Estimates with R-Value & Thickness Specs, fully insured for work in Spring and nearby areas.

My house is in one of the Spring subdivisions near the Grand Parkway, built in the 1990s. The master bedroom is always too hot in summer, and the cooling bill is out of control. What is going on?

That master bedroom is likely at the end of a duct run, or it sits over a garage where the attic temperature reaches 140 degrees or higher. The ductwork and insulation in that attic have lost their effectiveness over time. Spray foam seals the attic envelope, stops the duct leaks, and keeps the cooled air from escaping into the unconditioned space. We see this pattern constantly in Spring's 1990s stock, and foam fixes it.

I found wet insulation and condensation in my attic during a humid spell. Can you just spray foam over it?

No. We will not spray foam over wet, contaminated or leaking insulation. We remove it first, haul it away, let the attic dry, and then spray. That removal costs money upfront, but it is the only way to build a durable, mold-free system. If your attic is damp because of a roof leak or a plumbing issue, that has to be fixed before we spray. We fix the moisture first or we walk away. Call us at (346) 322-2588 to assess the damage.

What is the ballpark cost to remove old insulation and spray foam an attic in Spring?

Removal runs from $950 for a small attic to several thousand for a large one, depending on how much material is up there and how accessible it is. Foam then runs $1.20 to $1.50 per board foot for closed-cell. A typical 1,500 square foot attic with six inches of closed-cell, including removal, runs roughly $11,000 to $14,000. Open-cell is less expensive upfront but does not stop moisture the way closed-cell does in Houston's climate. Get a free estimate at (346) 322-2588.

Who decides the R-value and thickness I need in my Spring attic, and how does the building code work?

The current energy code for your address sets the minimum R-value. Spring is in Harris County, and the building official in Spring enforces the code that was in effect when your house was built or when you pull a permit for insulation work. We specify the R-value and thickness in our written estimate, and the building department inspects to make sure we hit it. The ignition barrier and thermal barrier rules (especially the fifteen-minute thermal barrier for attic insulation) are governed by code and inspected by the building official, not by us. Your local building department can tell you exactly what applies at your address.

Can I stay in my house while you spray foam the attic? What about the smell?

Yes, you can stay. We set up mechanical ventilation during the spray and cure process to manage odor. The smell is strongest during application and the first 24 hours. We recommend staying out of the attic area during that time and keeping bedroom doors closed if the attic is directly above living space. The foam is low-VOC once cured. The re-entry window is typically 24 to 48 hours, and we will tell you exactly when the space is safe to occupy normally again.

Are you insured for spray foam work on my Spring property?

Yes. We are fully insured with general liability and workers' compensation coverage. We carry the insurance that protects your property and our crew while we work. You can ask us for proof of coverage before we start.

When is the best time to do spray foam insulation in Spring? Should I wait for fall, or can I do it in summer?

Work runs year-round in Houston and Spring, but summer is actually the season when most homeowners decide to act. Your cooling bill hits its peak in July and August, and that is when people call to fix it. Summer heat also helps the foam cure faster. Fall and winter are quieter seasons, so you may have easier scheduling. The worst time is during hurricane season if there is active weather, but that is rare enough not to plan around. If your attic is damp or your insulation is wet, sooner is better than later, regardless of season.